Especially for carburetor lovers... It can be installed on both 4T and 2T engines. The design of the brackets and the curtain are designed for Ural/Dnepr motorcycles. In the future, changes are planned for other 2T equipment. Features: A hall sensor is used as a sensor. The input can be used with an optical sensor. Two coil control channels. An additional backup channel or for connecting a second coil. The channels work synchronously. DBM input sensor. The ignition card is two-dimensional. If an absolute pressure sensor is connected, the engine load can be taken into account when calculating the ignition angle. Built-in Bluetooth module. From an Android smartphone or laptop, it is possible to fully configure the ignition module (maps, algorithms, etc.), as well as control parameters. Two temperature sensor inputs. If you connect at least one, you can implement algorithms to protect the internal combustion engine from overheating. It also provides faster heating of the internal combustion engine at low temperatures. By connecting two sensors, the synchronicity of the cylinder heater can be monitored. The card switching input. When the login is activated, it switches to the second card. Adapted to the ignition coil Delphi GN10274-11B1 analog (MEAT & DORIA 10534, Bremi 20355...). These coils are mounted on a bracket from the kit without modification under the cover of Ural or Dnepr motorcycles. Configuration of the coil charge time. Install various ignition coils (Delphi GN10274, Bremi 20355, oka, uktus, sovek). The preferred charging time is reported for the official coils. Correction of the coil charge time depending on the supply voltage. Setting the cutoff speed. Stabilization of set revolutions XX . The module can support a preset XX way of adjusting the advance